Hello Howard, I have sent the same question to the list. I found I can calibrate the frequency with the 50 microvolt of the Elecraft XG-2. After calibration to that signal, I can even as well calibrate on the 1 microvolt signal of the XG-2. It appears as if the frequency of the SDR is too far off, it needs a very strong signal to calibrate on.
Something must have changed in between v1.8.0 and Beta 1.9.1 and SVN1382. RWM time signal is S9 here most of the time. It has never been any problem to calibrate the frequency on that signal. Maybe the software specialist of Flex can tell more. 73 Eddy ON5UQ. ----- Original Message ----- From: "Howard Benjamin" <[EMAIL PROTECTED]> To: <flexradio@flex-radio.biz> Sent: Thursday, August 02, 2007 8:54 AM Subject: [Flexradio] Freqency Calib Inop >I have just tried the new Power SDR Beta v1.9.1 and cannot calibrate the >frequency as I do with v1.8. When I check 'calibrate' I get a message 'Peak >is outside valid range'. My receiver is out of calibration by 160Hz against >my reference. Can anyone help? > > Regards > > Howard 5B4AHX > -------------- next part -------------- > An HTML attachment was scrubbed... > URL: > http://mail.flex-radio.biz/pipermail/flexradio_flex-radio.biz/attachments/20070802/96a28536/attachment.html > _______________________________________________ > FlexRadio mailing list > FlexRadio@flex-radio.biz > http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz > Archive Link: http://www.mail-archive.com/flexradio%40flex-radio.biz/ > FlexRadio Knowledge Base: http://kb.flex-radio.com/ > FlexRadio Homepage: http://www.flex-radio.com/ > _______________________________________________ FlexRadio mailing list FlexRadio@flex-radio.biz http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archive Link: http://www.mail-archive.com/flexradio%40flex-radio.biz/ FlexRadio Knowledge Base: http://kb.flex-radio.com/ FlexRadio Homepage: http://www.flex-radio.com/