I don't use VAC, and go by the KB article for doing the cal. The setting from months ago were phase:9.00 and gain:-18.70, I've been entering those values after rebuilding databases thru the evolution of the software.
73, Mike -----Original Message----- From: Neal Campbell [mailto:[EMAIL PROTECTED] Sent: Saturday, September 01, 2007 5:35 PM To: Mike Schelly Cc: [email protected] Subject: Re: [Flexradio] TX image rejection calibration One problem I discovered when doing this is to make sure you do not have VAC activated, otherwise no signal is transmitted and you have a very hard time! I spent a day fooling myself on that one! 73 Neal On 9/1/07, Mike Schelly <[EMAIL PROTECTED]> wrote: > Running 1.10.3 svn 1512...SDR-1000 > > I built a new database from scratch and was going thru calibrations > and now I find that phase has little if any control and the gain needs > to be backed out to -500. I'm transmitting with 5W into a dummy load > and monitoring on a FT-1000D listening to the opposite sideband for a > null. Anyone have a suggestion? > > 73, Mike K4EAR > > > _______________________________________________ > FlexRadio mailing list > [email protected] > http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz > Archive Link: http://www.mail-archive.com/flexradio%40flex-radio.biz/ > FlexRadio Knowledge Base: http://kb.flex-radio.com/ FlexRadio > Homepage: http://www.flex-radio.com/ > > _______________________________________________ FlexRadio mailing list [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archive Link: http://www.mail-archive.com/flexradio%40flex-radio.biz/ FlexRadio Knowledge Base: http://kb.flex-radio.com/ FlexRadio Homepage: http://www.flex-radio.com/
