I found that I was VERY susceptible to rfi on 80 meters and received some very critical comments on my audio during CQWWSSB. One person said it was a 'buzz'. Even though I could not hear any problem in the MON.
I'm working on the rfi problem and staying of 75 meters for the moment. the rfi problems do not appear on 20 through 10 where my audio reports are excellent. (fortunately I'm a cw op and only occasionally use phone) (and this is odd as the higher bands usually are more prone to rfi) On 11/3/2007 9:35:53 AM, Richard Stouffer ([EMAIL PROTECTED]) wrote: > OK and thanks. Disabling the MON killed that and I did finally get a > signal > report form someone, but > couldn't make out his call sign. He said there was > no echo, but, I think, he said I had a processor problem. Perhaps I'm > over > modulating. > I'll play around with latency after reading more about it in > Appendix A and then I'll > go try to find someone I can read a get a signal > report. > > Thanks agn, > Richard WU5k > > -----Original Message----- > From: FireBrick [mailto:[EMAIL PROTECTED] > Sent: Saturday, November 03, 2007 8:10 AM > To: [EMAIL PROTECTED] > Subject: Re: [Flexradio] Heil Headset/Yaesu Connector Assembly > > Disable MON, if > it's active when talking. > I 'think' what your hearing is the slight 'latency'. > Adjust the latency and see if it goes away. > I found that I could almost totally remove it. > > On 11/3/2007 7:56:37 AM, Richard Stouffer ([EMAIL PROTECTED]) wrote: > > OK, received the non-Icom headset from Heil last night and hooked it up > > to > > the Yaesu connector assembly from Heil to the front panel. It works > > fine > > so > > far as the cable assembly is concerned. > > > > > > > _______________________________________________ FlexRadio mailing list FlexRadio@flex-radio.biz http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archive Link: http://www.mail-archive.com/flexradio%40flex-radio.biz/ FlexRadio Knowledge Base: http://kb.flex-radio.com/ FlexRadio Homepage: http://www.flex-radio.com/
