Don, The only way to monitor 6 meters on RX2 is to use the RX1 tap or RX2 In. There is not a way to leave RX2 on Antenna 3, maybe this is your problem. I think that this will be corrected in later SW, but that is a Eric/Gerald question.
Make sure that the Preamp is turned off for both RXs.. before running the calibrations again, level and image. Eric found a bug in the SW somewhere.. Let us know. I use Thunderbird as a email client on replies it likes to balance out the reply sidebars for some reason , sure there is an option in there somewhere for that, but it's might unusual. Don wrote: > I turned on the radio and set RX2 to 6m - 50.1 mhz and RX1 was on 20m. > I then changed RX2 to 80mand then switched back to 6m and now the RX2 is > completely dead regardless of the band. I wonder if this might be the > result of not being able to calibrate both level and image on RX2? I > guess I will open the radio up and make sure all the cables are seated > and try again. Any thoughts here? > > Don - kx9q > > _______________________________________________ > FlexRadio Systems Mailing List > [email protected] > http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz > Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ > Knowledge Base: http://kb.flex-radio.com/ Homepage: > http://www.flex-radio.com/ > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > -- 73, Dudley WA5QPZ _______________________________________________ FlexRadio Systems Mailing List [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ Knowledge Base: http://kb.flex-radio.com/ Homepage: http://www.flex-radio.com/
