I don't have one, but based on the wiring diagram, Black=mic(+) White=PTT Shield=(PTT and mic ground)
The Shure 444 has a very narrow frequency response range (300-3000 Hz) with a gigantic pre-emphasis at 3000 Hz. The FLEX-5000 has a flat frequency response so you are going to probably have to use aggressive EQing to cut the 3000 Hz range to get it to sound acceptable. It is also a very high impedance mic, @ 10K ohms. The FLEX-5000 is not designed for high impedance and unbalanced loads and you may have to use a direct box (DI) to lower the impedance and convert the signal from an unbalanced to balanced load. IMHO, this mic is not well suited for the FLEX-5000, but that doesn't mean it can't be made to work. Good luck. -Tim -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Luther Bishop Sent: Tuesday, September 16, 2008 9:20 AM To: [email protected] Subject: [Flexradio] Shure 444 mic Has anyone ever mated a Shure 444 to the 5000? I just happen to have one on hand! Leon N5PU _______________________________________________ FlexRadio Systems Mailing List [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ Knowledge Base: http://kb.flex-radio.com/ Homepage: http://www.flex-radio.com/ _______________________________________________ FlexRadio Systems Mailing List [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ Knowledge Base: http://kb.flex-radio.com/ Homepage: http://www.flex-radio.com/
