I had this problem. RX2 showed a level of -241db. After trying everything I turned off the DC power supply -- not just the power switch, which didn't help -- for about a minute. Then RX2 resumed working. This happened twice.
Hope it helps. 73 Ed W2RF > -----Original Message----- > From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] > radio.biz] On Behalf Of Mack McCormick > Sent: Saturday, September 20, 2008 5:17 PM > To: flexradio@flex-radio.biz > Subject: [Flexradio] RX2 Not Working: Help Please > > RX2 has been working perfectly in the past. Today when I select RX2 the > panadapter is blank. No data at all. No line at all. Please offer any > suggestions. > > Running XP, latest firmware and PowerSDR. No other programs are running. > > I've tried the following: > > > I've allowed PowerSDR to create a new database. > > I've confirmed that Setup, Hardware Config, shows RX2: 2208-0126 (33C) > > I've run the receiver tests again. The "Image" test FAILS on all bands. > The "Level" test passes on all bands. > All suggestions gratefully accepted.73, MackWB4MAK > _______________________________________________ > FlexRadio Systems Mailing List > FlexRadio@flex-radio.biz > http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz > Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ > Knowledge Base: http://kb.flex-radio.com/ Homepage: http://www.flex- > radio.com/ _______________________________________________ FlexRadio Systems Mailing List FlexRadio@flex-radio.biz http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ Knowledge Base: http://kb.flex-radio.com/ Homepage: http://www.flex-radio.com/