Today I installed the Flex-5000A on my MacBook Pro. I proceeded
exactly according to the KB article of Brian, WB6RQN, starting with a
new 10GB windows partition in the Boot Camp mode. Everything went
fine, including the installation of Service Pack 3 (SP3) in Step 10
with no errors. But when I started the Flex-5000 driver I got the
message "No device found. Connect device". Though everything looked
fine and the tones were ringing when switching on and off the radio,
there was an interface problem with the firewire driver. Finally I
uninstalled the software including SP3 and installed instead the SP2-
hotfix KB885222. Now the radio works on the MacBook Pro, the CPU load
being around 20-40%. At the moment I am using 96kHz sample rate and
1024 buffer size in the operation mode 2 or 3.
So, according to my experience, Step 10 of the KB should me modified
or complemented.
73 Chris HB9AJP
_______________________________________________
FlexRadio Systems Mailing List
[email protected]
http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz
Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/
Knowledge Base: http://kc.flex-radio.com/ Homepage: http://www.flex-radio.com/
