I'm thinking your existing softrock install may not see the 5000A correctly. Just install Power SDR in a new directory like C:\Power-Flex. I just brought mine on line last night with XP and Vista32 without issue using a dual boot setup.
Cliff AB2ZS --- On Mon, 1/19/09, W7CE <w...@curtiss.net> wrote: From: W7CE <w...@curtiss.net> Subject: [Flexradio] Frequency tuning stops working To: FlexRadio@flex-radio.biz Date: Monday, January 19, 2009, 5:40 PM I just received my Flex-5000A today. I hooked it up and all looked good for a while. Then I was unable to change frequency. The frequency display changes, but the panadapter doesn't move. It appears that PowerSDR thinks it changed frequency, but the 5000 didn't respond. Only solution I've found so far is to power-cycle the box and start again. Unfortunately, this is happening within a few seconds to a few minutes of every restart. I'm using PowerSDR 1.16.1 and installed the drivers that came on the included CD. I already had PowerSDR loaded and had been using it with a SoftRock receiver with no problems. Any ideas? Thanks, Clay W7CE _______________________________________________ FlexRadio Systems Mailing List FlexRadio@flex-radio.biz http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ Knowledge Base: http://kc.flex-radio.com/ Homepage: http://www.flex-radio.com/ _______________________________________________ FlexRadio Systems Mailing List FlexRadio@flex-radio.biz http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ Knowledge Base: http://kc.flex-radio.com/ Homepage: http://www.flex-radio.com/