Mark- I believe this is a bug in 1.18 -- update to 1.18.1
Mark Lunday wrote:
SETUP: SDR 1.18, MixW 2.18, F3K, Vista SP2.
OBJECTIVE: Get MixW 2.18 working on digital modes.
ACCOMPLISHED: Sending CW from MixW 2.18, successfully reading frequency from
SDR 1.18 into MixW 2.18
FAILURE: Unable to activate TX from MixW 2.18 in BPSK31 mode.
STEPS FOLLOWED: Following along in the manual for F3K and SDR 1.18, pages
162-166, MixW config, everything on my end works flawlessly. Ending in the
lower 1/3 of page 166, I am able to generate CW from MixW2.18 to SDR 1.18.
MixW also correctly reads the frequency from SDR 1.18. So, everything
should be properly configured. Same procedure as described in page 144-146.
Works perfectly.
When I go to page 147 on digital operation with MixW, I note that the pic
shows the SDR in USB, although the setting should be DIGI-U. No prob, I set
it to DIGI-U. I follow steps 2, 3, and 4 on page 147. When I get to step 5
(click on TX) button, nothing happens in SDR. Anyone else able to get
digital out of MixW 2.18 who could point me to what I am doing wrong?
Mark Lunday
WD4ELG
<mailto:wd4...@arrl.net> wd4...@arrl.net
<http://wd4elg.net> http://wd4elg.net
_______________________________________________
FlexRadio Systems Mailing List
FlexRadio@flex-radio.biz
http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz
Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/
Knowledge Base: http://kc.flex-radio.com/ Homepage: http://www.flex-radio.com/
_______________________________________________
FlexRadio Systems Mailing List
FlexRadio@flex-radio.biz
http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz
Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/
Knowledge Base: http://kc.flex-radio.com/ Homepage: http://www.flex-radio.com/
