The answer is DDUtil Without it you can only connect one CAT enabled software package to PowerSDR.
Also dump vCom. Go with Com0Com or the VSP (Eltima) drivers for virtual com port pair software. -Tim -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Mark Lunday Sent: Tuesday, October 27, 2009 2:58 PM To: [email protected]; [email protected] Subject: [Flexradio] Dumb question about com0com And maybe N8VB COM Emulator, this question applies also. I admit I am hard-headed, but I am confused about something. I have F3K, MixW, and OmniRig (let's go with this as an example). I want MixW and OmniRig to both read and control the frequency of the F3K. I set up a virtual Serial Port pair in either com0com or N8VB; let's say it is COM 7/COM 17. I then select COM 7 under CAT in the Power SDR, and COM 17 under MixW. Works like a charm. Now, I want OmniRig to also control the frequency (so I can use CW skimmer). So I pick COM 17 under Omni Rig.whoops, already in use. So I go to create another pair of COM 8/COM 18. I select COM 18 for OmniRig.but wait, if I pick COM8 for the SDR then it no longer works with MixW. Maybe the answer is right in front of me. Mark Lunday WD4ELG Hillsborough, NC - FM06kb <mailto:[email protected]> [email protected] <http://wd4elg.net> http://wd4elg.net <http://wd4elg.net> http://wd4elg.blogspot.com _______________________________________________ FlexRadio Systems Mailing List [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ Knowledge Base: http://kc.flex-radio.com/ Homepage: http://www.flex-radio.com/ Message delivered to [email protected] _______________________________________________ FlexRadio Systems Mailing List [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ Knowledge Base: http://kc.flex-radio.com/ Homepage: http://www.flex-radio.com/ Message delivered to [email protected]
