You have done everything correctly. Contact Dudley directly at FlexRadio support ([email protected]) so he can triage the problem with 6m.
-Tim -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Ed Stallman Sent: Friday, December 04, 2009 5:27 PM To: [email protected] Subject: [Flexradio] no power out 6 m zero watts This happened when I updated SVN PB-Pal , My power on the HF bands went to 150 watts . I did the Ctrl Shift F to calibrate the power, all calibrated fine until it got to 6m . At that point PSDR would stop and shut down. Reading the mail on the reflector, I read were all calibrating need's to be done using the official release. Today I installed Drivers,Firmware and PSDR from the Flex web page (front page) Doing the power calibrate, all HF bands did fine, This time when it got to 6m, it did not shut down PSDR ... It just sat there and did nothing, I could see a wave form in the filter bandwidth and the Mox tab was highlighted . I Gave it may be 5 minutes before clicking X and stop on PSDR I tried this with 2 different OS, windows XP home and Windows 7 32 bit. their was no change with either, So were did my 100 watts go on 6m ? Yes I was in 96k and 1024 Yes I used a dummy load on port one yes it was a new data base Radio Flex 5000a Thanks for any help , Ed _______________________________________________ FlexRadio Systems Mailing List [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ Knowledge Base: http://kc.flex-radio.com/ Homepage: http://www.flex-radio.com/ Message delivered to [email protected] _______________________________________________ FlexRadio Systems Mailing List [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ Knowledge Base: http://kc.flex-radio.com/ Homepage: http://www.flex-radio.com/ Message delivered to [email protected]
