I should have mentioned the RX2 is connected to the RX1 tap.
----- Original Message -----
From: "Clay W7CE" <w...@curtiss.net>
To: <flexradio@flex-radio.biz>
Sent: Sunday, December 20, 2009 12:59 PM
Subject: [Flexradio] 5000A RX1 Preamp affects RX2
I recently installed PowerSDR 1.18.3 on a new Windows 7 system (Flex 5000A,
Firmware: 1.3.0.8, Firewire driver: 3.5.0.7171). The install went well and
PowerSDR and the 5000A seem to be working fine. However, turning on the
RX1 preamp causes the RX2 S-Meter reading to increase by about 20dB. With
both receivers on 20M and VFO Sync enabled, turning on the RX1 preamp
causes the signal to noise ratio on RX2 to get noticeably worse (RX2 preamp
also on) by about 20 dB. I recall this problem being reported earlier this
year, but I thought it had been fixed. Is this a known problem with
1.18.3? Is anyone else observing this?
73,
Clay W7CE
_______________________________________________
FlexRadio Systems Mailing List
FlexRadio@flex-radio.biz
http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz
Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/
Knowledge Base: http://kc.flex-radio.com/ Homepage:
http://www.flex-radio.com/
Message delivered to w...@curtiss.net
_______________________________________________
FlexRadio Systems Mailing List
FlexRadio@flex-radio.biz
http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz
Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/
Knowledge Base: http://kc.flex-radio.com/ Homepage: http://www.flex-radio.com/
Message delivered to arch...@mail-archive.com