Greetings gents,
Using the quick record button on the PowerSDR console I've noticed that the
low bass response is lacking when compared to the original. That is, the bass
in not as deep and full as the original. I've checked my transmit bandwidth and
made sure it was as wide as the receive filter (from 0 to 3100) but I was
wondering if there were any other parameter that would affect the recording
frequency response.
I'm using Power SDR 1.18.3 and 1.18.5 with the SDR-1000 & Edirol FA66 at 192K.
The sampling rate is currently 48000 but the other rates didn't seem to change
the response either.
My recordings were compared with a Flex 5000A which reproduced the signals
faithfully.
Could this be a limitation of the SDR-1000?
Edwin Marzan AB2VW
_________________________________________________________________
Hotmail: Free, trusted and rich email service.
http://clk.atdmt.com/GBL/go/201469228/direct/01/
_______________________________________________
FlexRadio Systems Mailing List
FlexRadio@flex-radio.biz
http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz
Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/
Knowledge Base: http://kc.flex-radio.com/ Homepage: http://www.flex-radio.com/
