I used only the Flex-5000 and its scope.... no fancy outboard frequency standard or software. Several signals seemed quite spongy probably due to Doppler. I had little confidence in any of my readings, which was quite frustrating.
I didn't get home from work in time for the two 20 meter runs. On those I submitted, my error was +0.188, -0.318, and -0.328 Hz . I didn't submit a 40 meter report because W6OQI's signals were at noise level here and I didn't believe the 7057000.0 I was getting. Turned out that was about right. Once again the Flex has proven to be well within specs on every frequency. One new thing I did this time to improve my results was to calibrate the 5000 with the nearest WWV/CHU transmission between band changes. Calibration takes just a few seconds. Jeff K0OD _______________________________________________ FlexRadio Systems Mailing List FlexRadio@flex-radio.biz http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ Knowledge Base: http://kc.flexradio.com/ Homepage: http://www.flexradio.com/