Bob: If you are using VAC to connect the audio between PowerSDR and MixW, make sure that the settings inside VAC are not causing re-sampling to occur. Since the default sampling rate for PCs is 44.1 ksps, rather than the 48 ksps that the 1500 runs at, sometimes VAC will resample to 44.1, then resample back to some multiple of 12 for the audio decoder programs. Make sure that all sample rates in VAC are set at 48 ksps. (or 12 or 24)
--- Graham == On Wed, May 11, 2011 at 11:57 AM, F5UL <[email protected]> wrote: > Good evening, all on the list! > I'm new member and user of Flex products, but i'm not ignorant about SDR > and direct conversion Rx/Tx. > The Flex-1500 is a wonderfull transceiver, in use since 3 days and working > without problems with Ham Radio de Luxe, > MixW 3.0.1b, WSPR.... > I have a, let say, small problem with MixW, witchever version, with the > waterfall display. It's not sharp and easy to read or > distinct each signal... > With HRD no problem, each signals are well defined... > Did anybody have an explication or an answer on this problem? > Thank you in advance, good evning! > F5UL - Bob > _______________________________________________ > FlexRadio Systems Mailing List > [email protected] > http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz > Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ > Knowledge Base: http://kc.flexradio.com/ Homepage: > http://www.flexradio.com/ > _______________________________________________ FlexRadio Systems Mailing List [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ Knowledge Base: http://kc.flexradio.com/ Homepage: http://www.flexradio.com/
