I am running the same gauntlet with my new Flex5000A connected to a
MacBookPro running BootCamp and Win7Pro64.
I know that I dug myself in pretty deep for my first attempt with an
SDR. I periodically have audio, but more often, when PowerSDR can find
the radio, there is no audio. It seems that I have best luck by shutting
everything down in order, and rebooting the computer completely before
powering up the radio. It will usually run for a while, and eventually
stop outputting audio. The spectrum display continues as normal, but no
sound.
And then there are the failed attempts to upgrade the firmware...
I tried going onto the FlexWiki where I understand that there is a good
discussion on setting up the Mac environment, only it looks like the
site has been hacked.
Is there an available setup guide that might help me figure out what I
am doing wrong?
Jim, NS2K
On 6/21/2011 9:49 PM, Mike Schwendeman wrote:
Update: I did a SYSTEM RESTORE to a point well before I had been gone;
- Restore went well
- Restarted computer
- Run FLEXRADIO; "No devices found"
So, no help; I undid this restore, so I am back to today's efforts
position...
73; -Mike- KØJTA
_______________________________________________
FlexRadio Systems Mailing List
[email protected]
http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz
Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/
Knowledge Base: http://kc.flexradio.com/ Homepage:
http://www.flexradio.com/
_______________________________________________
FlexRadio Systems Mailing List
[email protected]
http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz
Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/
Knowledge Base: http://kc.flexradio.com/ Homepage: http://www.flexradio.com/
