Guy,
It's really easy with WWV (or you can use any other high calibrated
signal) , go to the Calibration tab of Setup, page 132 of the current
Owners Guide, click the Expert box, with a good signal on WWV, at
least a S5 on the meter, be sure to match the frequency box to the WWV
or generator frequency and click Start.. Wait a few seconds for the
Finished message.. That's it..
73,
Dudley
On 7/14/2011 8:30 PM, Guy Harris wrote:
Just how does one check the frequency calibration on a F5k?
TIA,
~~Guy
W6NJX
On 7/14/2011 5:45 PM, Dudley Hurry wrote:
Kevin,
Make sure that you have followed the frequency calibration for your
radio.. then check your radio.. If you must, you can offset the
DDS , but that will effect the other frequencies severely.
73,
Dudley
WA5QPZ
On 7/14/2011 10:03 AM, Kevin Hobbs wrote:
Hi
I always find that I like the sound of a station on SSB when I tune
100 Hz
off .. ie: 50.109900 instead of 50.110.
Is there an easy way to put this 100Hz offset into the powerSDR setup?
73 Kevin
_______________________________________________
FlexRadio Systems Mailing List
FlexRadio@flex-radio.biz
http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz
Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/
Knowledge Base: http://kc.flexradio.com/ Homepage:
http://www.flexradio.com/
_______________________________________________
FlexRadio Systems Mailing List
FlexRadio@flex-radio.biz
http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz
Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/
Knowledge Base: http://kc.flexradio.com/ Homepage:
http://www.flexradio.com/
_______________________________________________
FlexRadio Systems Mailing List
FlexRadio@flex-radio.biz
http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz
Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/
Knowledge Base: http://kc.flexradio.com/ Homepage: http://www.flexradio.com/