Jerry is correct on all points. The FLEX-5000 has a stout front end and it will take a signal in excess of 0 dBm to saturate the ADCs.

You should be OK unless the RX antenna is in the near field of the transmitting antenna and you are running very high power. My antennas are in the near field of each other (5' separation) and I have no issues at 100 watts other than pegging the S meter on the RX2 :-)

If you are worried about it, then there are some devices that will switch out the RX antenna when transmitting from companies like DX Engineering and Heros just to name two.

-Tim
--
Tim Ellison, W4TME
Product Management, Sales & Support
FlexRadio Systems^(TM)
4616 W Howard Ln Ste 1-150
Austin, TX 78728
Phone: 512-535-4713 Ext. 223
Email: t...@flexradio.com <mailto:t...@flexradio.com>
Web: www.flexradio.com <http://www.flexradio.com>

logo
/Tune In Excitement^(TM)
PowerSDR^(TM) is a trademark of FlexRadio Systems/


On 8/24/2011 11:36 AM, Jerry Flanders wrote:
This has been discussed before, and Gerald posted some actual RF levels that were known to be safe for the receiver front end. I would simply measure on all bands and verify that my setup was below these levels. Attenuate in some way if not.

Search the archives for the earlier posts on this and Google "flex gerald w4uk level" and see my July 19, 2009 post for more.

BTW, lack of "muting" is not an oversight. In fact, unmuted simultaneous receive is one of the features of the 5000 that Flex mentions on 5000 features page http://www.flex-radio.com/Products.aspx?topic=f5k_features : "The FLEX-5000 was designed from the ground up to be a true full duplex radio that can transmit and receive simultaneously without the need for a second installed receiver. With this capability, the FLEX-5000 is positioned to be the ultimate CW rig ever made. For phone use, you will be able to monitor your actual audio that is being transmitted rather than using a monitor circuit in the audio chain. "

Jerry W4UK

At 10:48 AM 8/24/2011, John Wagner wrote:
All, As I understand this, when using RX2 with a receive-only antenna ( for
example) and the RX2 input configured to RX2 IN, there is no protection
for RX2 during transmit. The only time there is protections for RX2 occurs when the input is set to RX1 Tap. Makes using a separate antenna on RX2 a
potentially
harmful thing. I supposed you have to build/buy a external relay or some
other scheme.

Seems like a bit of an oversight.

73, John W8JJW


_______________________________________________
FlexRadio Systems Mailing List
FlexRadio@flex-radio.biz
http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz
Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/
Knowledge Base: http://kc.flexradio.com/ Homepage: http://www.flexradio.com/
_______________________________________________
FlexRadio Systems Mailing List
FlexRadio@flex-radio.biz
http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz
Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/
Knowledge Base: http://kc.flexradio.com/  Homepage: http://www.flexradio.com/

Reply via email to