Rob, Search the Knowledge Center for "Edit BandText Table". The article is old & refers to the .mdb file used by earlier versions of PowerSDR. However, the principles are still the same. The only difference is that you will be editing a .XML file.
73, Ray, K9DUR http://k9dur.info -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Rob Keijzer Sent: Friday, May 11, 2012 3:40 PM To: Flexradio reflector Subject: [Flexradio] Customising Band text Hi everybody, I'd like to edit the text below the frequency readouts to something more applicable to my band plan. For instance "40M Extra CW" would simply be "40m CW" here in the Netherlands. I once read an article about this, but it seemed to involve editing an .mdb file, which I couldn't find then. But I remember that at that time my Flex5kA hadn't arrived still, so I was running PSDR in demo mode. I lost track of the article in the mean time. Can someone shed some light on this? TU 73 Rob, PA3CNT _______________________________________________ FlexRadio Systems Mailing List [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ Knowledge Base: http://kc.flexradio.com/ Homepage: http://www.flexradio.com/ _______________________________________________ FlexRadio Systems Mailing List [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ Knowledge Base: http://kc.flexradio.com/ Homepage: http://www.flexradio.com/
