That is not how XIT/RIT works. The VFO frequency display does NOT
change, but the actual RX or TX frequency does.
Tune into a station. Enable RIT. Change the value to 2000 (Hz). You
should hear the signal go off frequency, hence the Receive Incremental
Tuning (RIT) is working.
Tim Ellison
On 9/15/2012 12:04 PM, rcole...@twcny.rr.com wrote:
Greetings...I’m sure it’s operator error but when I make the XIT or RIT active
and increase or decrease the values nothing happens. I’ve never used the XIT or
RIT before so perhaps I’m doing something wrong. I assume that the frequency
readout would change but it doesn’t. Thanks!
_______________________________________________
FlexRadio Systems Mailing List
FlexRadio@flex-radio.biz
http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz
Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/
Knowledge Base: http://kc.flexradio.com/ Homepage: http://www.flexradio.com/
_______________________________________________
FlexRadio Systems Mailing List
FlexRadio@flex-radio.biz
http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz
Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/
Knowledge Base: http://kc.flexradio.com/ Homepage: http://www.flexradio.com/
