Hi Dave!

Here you can find my setup. I use flex3000, vac 4.12 and CWskimmer 1.8.

https://www.dropbox.com/s/kmo54lvrgciers4/CWSkimmer%20config%20Flex253.pdf

The only thing I am not sure wheather that is maximum I can receive or I
have misconfigured is that I can only RX 24KHz of spectrum.

73,
Goran ANDRIC, S55OO



On Fri, Mar 1, 2013 at 6:10 AM, Dave Blaschke <[email protected]> wrote:

> I have now installed PowerSDR 2.5.3, and I need some help getting
> CWskimmer 1.8 working with it. My problem is that I cannot make the CW
> signal traces on the waterfall match the frequency. I had no problem with
> this on earlier versions of PSDR.. I have tried many combinations of  Audio
> I, hz to no avail.
>
> If anyone  has this combination working properly, I would appreciate
> hearing from you
>
> Dave, W5UN
>
>
> ______________________________**_________________
> FlexRadio Systems Mailing List
> [email protected]
> http://mail.flex-radio.biz/**mailman/listinfo/flexradio_**flex-radio.biz<http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz>
> Archives: 
> http://www.mail-archive.com/**flexradio%40flex-radio.biz/<http://www.mail-archive.com/flexradio%40flex-radio.biz/>
> Knowledge Base: http://kc.flexradio.com/  Homepage:
> http://www.flexradio.com/
>
_______________________________________________
FlexRadio Systems Mailing List
[email protected]
http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz
Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/
Knowledge Base: http://kc.flexradio.com/  Homepage: http://www.flexradio.com/

Reply via email to