Hi Larry, I just fought this problem last weekend. For me I needed to put a check mark in the I/Q settings on the righthand side of the page on the VAC tab in PowerSDR so you are sending the I and Q stream and not the processed audio. Hope this helps.
Jerry > On Nov 6, 2013, at 2:11 PM, Larry Bryan <la...@w8lig.com> wrote: > > I decided to try CW Skimmer with my Flex 5K I have read the postings on the > Flex site as well as those provided by Afreet software. I got it working in > the 3-Khz mode and then moved on to the SoftRock-IF mode. > > The issue I have is that the CW Skimmer waterfall and the Flex 5k > panadapter do not follow each other in frequency. I had a CW signal tuned > in on the Flex at 600hz but the CW skimmer display had nothing at that > frequency. > > The other issue was I had VAC1 set for Fldigi using MME VAC Lines 1 and > line 2 I have the skimmer set up for direct I/Q WDM-KS VAC lines 3 and 4. I > wanted to be able to run both at the same time. > > CAT is working. Since I'm new to this I'm looking for suggestions. > 73 > Larry - W8LIG > _______________________________________________ > FlexRadio Systems Mailing List > FlexRadio@flex-radio.biz > http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz > Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ > Knowledge Base: http://kc.flexradio.com/ Homepage: http://www.flexradio.com/ _______________________________________________ FlexRadio Systems Mailing List FlexRadio@flex-radio.biz http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ Knowledge Base: http://kc.flexradio.com/ Homepage: http://www.flexradio.com/