Hi Marty, W8AKS
I don't know your specific combination but I do use the Flex 3000 with the
ALS-500M and ARI-500.
You will need to make up a cable from the computer to the ARI-500 and this
can be done a couple
of different ways. My setup uses a parallel port cable to the ARI-500 and
DDutil to send band
information to the ARI-500. Since your setup is most likely different than
mine you will need to
do some research on how to interface the two. Once done it works fine.
Good Luck with your project.
Don, kd6hq
-----Original Message-----
From: Marty Bluhm
Sent: Thursday, December 05, 2013 10:01 AM
To: Flex Radio
Subject: [Flexradio] Use of Ameritron ARI500/ALS 600S with Flex5K
I am considering purchasing the ari 500 to further automate my station. Has
anyone used this combo? If so, any problems? Will DDutil handle the
interfacing?
New kid at this, so please bear with me.
Thanks and 73
Marty
W8AKS
Sent from my iPad
_______________________________________________
FlexRadio Systems Mailing List
FlexRadio@flex-radio.biz
http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz
Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/
Knowledge Base: http://kc.flexradio.com/ Homepage:
http://www.flexradio.com/
_______________________________________________
FlexRadio Systems Mailing List
FlexRadio@flex-radio.biz
http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz
Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/
Knowledge Base: http://kc.flexradio.com/ Homepage: http://www.flexradio.com/
