Hi All,
I am trying to get egress netflow working on a Cisco 2811 router with
only one physical interface. Its running 12.3(14)T so it should support
egress netflow. (introduced in 12.3(11)T according to this web page).
http://www.cisco.com/univercd/cc/td/doc/product/software/ios124/124cg/hn
f_c/ch05/nfb_bega.htm
The ingress direction is working fine, but I get no egress data. The
relevant section of my run config is pretty obvious.
interface FastEthernet0/0
ip address 10.0.0.1 255.255.255.0
ip flow ingress
ip flow egress
duplex full
speed 100
end
I have tried most permutations of the following options without success
with and without cef
with and without an "ip route-cache flow" entry.
V1 and V5 format
with and with out ingress netflow
Does anyone have any tips on what I need to do here?
Cheers
Alistair
**********************************************************************
Registered Office:
Marks and Spencer plc
Waterside House
35 North Wharf Road
London
W2 1NW
Registered No. 214436 in England and Wales.
Telephone (020) 7935 4422
Facsimile (020) 7487 2670
<<www.marksandspencer.com>>
Please note that electronic mail may be monitored.
This e-mail is confidential. If you received it by mistake, please let us know
and then delete it from your system; you should not copy, disclose, or
distribute its contents to anyone nor act in reliance on this e-mail, as this
is prohibited and may be unlawful.
2005
_______________________________________________
Flow-tools mailing list
[EMAIL PROTECTED]
http://mailman.splintered.net/mailman/listinfo/flow-tools
