Hi, I am able to create a log file with gdb now (each time they are a little different)
I updated and ugraded fluxus (I had 0.17 installed but still around 23 parts where updated. Still those crashes occure. ... What see very often happen is when I start fluxus are the following frases: Udevd[1072]: can not read'/etc/udev/rules.d/280_users.rules 9.019522] ath5k phy0: noise floor calibration failed (2427 MHz) 9.231432] ath5k phy0: noise floor calibration failed (2427 MHz) After that laptop stops starting up and stays with this screen. Then I need to reboot the laptop (via power button) Next time I will post my gdb file again. Br, Elmer -----Original Message----- From: gabor papp [mailto:[email protected]] Sent: zaterdag 15 mei 2010 7:23 To: Elmer & Maddy Cc: 'Dave Griffiths'; [email protected] Subject: Re: [Fluxus] zsh: abort > I get these errors only when I move my object with my mouse or mouse pad. > When I run my scripts with the F5..no errors occur. don't forget to set your .gdbinit file before debugging fluxus. like this: http://www.mail-archive.com/[email protected]/msg00512.html best, gabor
