Sorry, I take your point. There have been occasions when I have sweated over a problem whose solution was not software related.
John Marshall Accurate Software 80 Peach Street, Wokingham, Berkshire, RG40 1XH, UK. Tel: +44 (0)118 977 3889 Fax: +44 (0)118 977 1260 http://www.accuratesoftware.com <http://www.accuratesoftware.com> -----Original Message----- From: Matthew Case [mailto:[EMAIL PROTECTED] Sent: 24 February 2004 13:16 To: [EMAIL PROTECTED] Subject: RE: Yet another pagination issue Well, the issue is that these letters go all over the country...so one letter may need text specific for Utah while the next 5 may go to Maine. Obviously we could configure the software to print only letters going to specific states at a time, but management would rather the program spit out the appropriate text on a per-letter basis. -----Original Message----- From: John Marshall [mailto:[EMAIL PROTECTED] Sent: Tuesday, February 24, 2004 4:31 AM To: [EMAIL PROTECTED] Subject: RE: Yet another pagination issue How fancy is your printer and what sort of print run do you do? Why not print your letter text single-sided and do a bulk run before or after to print your legal text on the back? The way you describe it, the legal text sounds as if it does not vary. John Marshall Accurate Software 80 Peach Street, Wokingham, Berkshire, RG40 1XH, UK. Tel: +44 (0)118 977 3889 Fax: +44 (0)118 977 1260 http://www.accuratesoftware.com -----Original Message----- From: Matthew Case [mailto:[EMAIL PROTECTED] Sent: 23 February 2004 18:58 To: [EMAIL PROTECTED] Subject: Yet another pagination issue The ongoing saga of my FOP-driven letter engine continues. Now, management has requested that I create letters that are comprised of 2 pages. The letter text on the first page, and state-specific legal text on the back. First, I want to specifically say "this text can only go on even pages" and "that text can only go on odd pages". If the letter text goes over one page, I want the text to roll onto a third page and leave the state specific text only on page 2. Secondly, my engine right now appends multiple FO documents together to create one bulk PDF. I'm assuming I will be using the <fo:page-sequence-master master-name="alternating"> tag to control what goes on even and odd pages, given the first issue, will the solution be friendly to this? Finally, it's all good and well if it's able to be done using XSL:FO...I obviously am searching for a solution that FOP 0.20.5 supports. Any ideas? - Matt Case -- Accurate Software [EMAIL PROTECTED] www.accuratesoftware.com Europe . North America . Australasia . Africa The information in this email is confidential and privileged and is intended only for the use of the individual or entity listed above. If you are neither the intended individual, or entity listed above, nor the person responsible for the delivery of this email to the intended recipients, you are hereby notified that any unauthorised distribution, copying or use of this email is prohibited. If you have received this email in error, please notify the Accurate system manager at [EMAIL PROTECTED] or on +44 (0)118 977 3889. The views expressed in this communication may not necessarily be the views held by the Accurate Group. This e-mail has been virus checked by 'Knowledge Checker' http://www.imhotek.com --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED] --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED] --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
