Yes, you can. Simply select all of the data you'd like to mirror. Use the
'MoveObject' command and locate the mirror point, then use the 'X' key to
mirror from left to right, or the 'Y' key to mirror from top to bottom.
Craig Wiper
Wescam
-----Original Message-----
From: Robison Michael R CNIN [mailto:[EMAIL PROTECTED]]
Sent: Wednesday, May 09, 2001 7:05 AM
To: 'Protel EDA Forum'
Subject: [PEDA] mirror layout
[Robison Michael R CNIN] hello,
i've been doing a series of small two-sided boards and i'm just
going from an old pcb when i do the work, along with a drill hole
spec.
what i'm wondering is if i can flip the rear side when i'm laying it
out so that i don't have to mentally mirror it. i looked under view
in the menu and in the help utility but no luck.
thank you, miker
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
* - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
