i will heartily second that!
Dennis Saputelli
Abd ul-Rahman Lomax wrote:
>
> At 11:40 AM 6/28/01 -0400, [EMAIL PROTECTED] wrote:
> >I find that the part manufacturers are at least consistent. I wish Protel's
> >footprint wizard would actually use the dimensions supplied by the vendors,
> >particularly QFP packages.
>
> This is a problem with Wizard SMT footprint creation in general. It's
> fairly apparent that whoever finally approved the Wizard was never forced
> to actually use it. It is typically necessary to sit down and manually
> calculate the dimensions that the Wizard wants instead of just feeding it
> data from the mfr. information. It's usually easier to bypass the Wizard
> and build the footprint directly.
>
> [EMAIL PROTECTED]
> Abdulrahman Lomax
> P.O. Box 690
> El Verano, CA 95433
--
___________________________________________________________________________
www.integratedcontrolsinc.com Integrated Controls, Inc.
tel: 415-647-0480 2851 21st Street
fax: 415-647-3003 San Francisco, CA 94110
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
* - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
