Dual-mode is not supported at the ServerIron XL as far as I remember
- dual-mode ports are only available using the devices which came out
after the XL. The XL is a pretty old box.
- Oliver
At 23:36 12.01.2009, Calvin Gorriaran wrote:
Content-Language: en-US
Content-Type: multipart/alternative;
boundary="_000_3DFFCADFA43AB74890E06352129CDE6C19D707EDE9MBX1EXCHPRODU_"
Hi Mike,
These are my choices in an interface that has been tagged. I think I
may just be too far behind on firmware.
ver 07.4.01T12
(config-if-e100-1)#
auto-gig Handshaking with other Gig port to
exchange capability
info
broadcast Broadcast traffic
cache-group TCS cache group
clear Reset functions/remove keys
dhcp-gateway-list DHCP Assist - set gateway address for each subnet
disable Disable
enable Enable
end End config-level commands
exit Exit current level commands
flow-control 802.3x flow control on full duplex port
fw-group firewall group
ip IP commands
ip-multicast-disable Disable IP multicast on this interface
ip-policy IP access filter commands
ipg10 Inter-Packet Gap delay for 10M Ethernet
ipg100 Inter-Packet Gap delay for 100M Ethernet
ipg1000 Inter-Packet Gap delay for Gig Ethernet
mac MAC filter commands
monitor Monitored port
multicast Multicast traffic
neg-off No handshake for the port
no Undo commands
phy-mode Bay 28000 compatibility mode
port-name Assign alphanumeric port name
pvst-mode Interoperate with Cisco PVST+ for
multi-spanning tree
qos-priority QOS priority
quit Exit to user level
rshow Remote show system information
show Show system information
spanning-tree STP port commands
speed-duplex 100 or 10, half or full
unknown-unicast Unknown unicast
write Write running configuration to memory or terminal
_______________________________________________
foundry-nsp mailing list
[email protected]
http://puck.nether.net/mailman/listinfo/foundry-nsp
_______________________________________________
foundry-nsp mailing list
[email protected]
http://puck.nether.net/mailman/listinfo/foundry-nsp
