Hi Nghia.
Thank you your reply, i already fix issue with my hands ;)
PBR working fine as i see now, i made a mistake in the graphs and turned by PBR less of traffic than expected...
:)
Regards,
|
> |
Hi, What you did is applying the PBR globally. Did you try to apply locally to the interface. Smt like (x.x.x.x)----- e1/1 ---- B4000 e1/2 y.y.y.y ---------------> To enable PBR locally, enter commands such as the following: BigIron(config)# interface e1/1 BigIron(config-vif-1)# ip policy route-map pbr-map The commands in this example change the CLI to the Interface level for virtual interface 1, then apply the ??????testroute?????? route map to the interface. You can apply a PBR route map to Ethernet ports or virtual interfaces. On Sat, Mar 7, 2009 at 12:16 PM, Sheremet Roman <[email protected]> wrote: Hi there, Have problem with setup PBR on BigIron 4000, ========================================================================== ?? SW: Version 08.0.01qT53 Copyright (c) 1996-2004 Foundry Networks, Inc. ?? ?? ?? Compiled on Jun 16 2008 at 12:07:44 labeled as B2R08001q ?? ?? ?? (3856667 bytes) from Primary B2R08001q.bin ?? HW: BigIron 4000 Router, SYSIF version 21, Serial #: Non-exist ========================================================================== SL 1: J-BxGMR4 JetCore Management Module, SYSIF 2 (Mini GBIC), M4, ACTIVE ?? ?? ?? Serial #: ?? CH06031196 ?? 4096 KB BRAM, JetCore ASIC IGC version 49, BIA version 89 32768 KB PRAM and 2M-Bit*1 CAM for IGC ?? 0, version 0449 32768 KB PRAM and 2M-Bit*1 CAM for IGC ?? 1, version 0449 ========================================================================== ip policy route-map pbr-map access-list 102 permit ip host x.x.x.x any route-map ?? pbr-map permit ?? 10 ?? match ip address ?? 102 ?? set ip next-hop y.y.y.y So, that should route packets from x.x.x.x host to y.y.y.y gateway, but this is not working, i have high CPU load (30-50%) when i turn on "ip policy", and if i turn it off load is 1-2%... But packets doesnt going to needed gateway. I look this maillist before and found same problem there: http://www.gossamer-threads.com/lists/nsp/foundry/13915?search_string=pbr;#13915 But without real solution. Anyone fix this issue ? Possibe need try another firmware of something like this... ? P.S: Sorry for my english, i`m from UA. Regards, _______________________________________________ foundry-nsp mailing list http://puck.nether.net/mailman/listinfo/foundry-nsp -- Nghia, Nguyen Duy 908 Bergwijkdreef 1112XZ Diemen The Netherland Tel: +31(0)624.63.83.98 |
--
?? ??????????????????,
Sheremet mailto:[email protected]
_______________________________________________ foundry-nsp mailing list [email protected] http://puck.nether.net/mailman/listinfo/foundry-nsp
