It looks like you're applying the PBR at the global level and not at the interface level. Can't say I have any experience with that myself.
Here's what works for me: ip policy prefer-direct-route ip route 0.0.0.0 0.0.0.0 172.30.69.1 ! interface ve 5 ip address 172.30.67.3 255.255.255.128 ip policy frag-match-src ip policy route-map WWW-DMZ ip vrrp-extended vrid 7 backup priority 210 ip-address 172.30.67.2 track-port e 2/1 track-port e 2/2 enable ! access-list 100 permit ip 172.30.67.0 0.0.0.127 any ! route-map WWW-DMZ permit 10 match ip address 100 set ip next-hop 172.30.67.1 Scott On Tue, Jun 15, 2010 at 11:34 AM, Lazuardi Nasution <[email protected]>wrote: > Hi Scott, > > Following is the related config. I can do HTTP on both VIP at the same > time but I only can do DNS and PING to VIP2 if VIP1 is disconnected. > Please help. > > Best regards, > > > <snip> > > > > From: "Scott T. Cameron" <[email protected]> > > To: [email protected] > > Date: Tue, 15 Jun 2010 10:29:25 -0400 > > Subject: Re: [f-nsp] Route-Map Problem > > I don't know why you're seeing that, because the route-map's ACL > shouldn't care about whether it's DNS or HTTP. It should just care about > src/dst networks at worst. > > Can you show the exact config you're using? > > Scott > > > > On Tue, Jun 15, 2010 at 12:36 AM, Lazuardi Nasution < > [email protected]> wrote: > >> > >> Hi Scott, > >> > >> I have done with HTTP, the PBR works for HTTP request. But, there is > >> problem with DNS. It seem that DNS reply doesn't follow PBR. I can see > >> that the VIP receives DNS > >> request but I think the reply is forwarded to the wrong gateway. Any > >> suggestion ? I have tried ip policy > >> frag-match-src/frag-match-dest/frag-match-src-dest with no success. > >> > >> Best regards, > >> > >> > From: "Scott T. Cameron" <[email protected]> > >> > To: [email protected] > >> > Date: Fri, 28 May 2010 06:47:23 -0400 > >> > Subject: Re: [f-nsp] Route-Map Problem > >> > The ServerIron platform is generally very sensitive to the order of > things. I've had this exact same problem before -- and banged my head > against the wall. > >> > However, you are missing one important thing on your config: ip > policy frag-match-source. This will insure that all packets are treated. > >> > > >> > I'd start over, removing all the relevant PBR lines. Enter in the ACL > first, exit, write mem. Enter in the route-map, exit, write mem. Finally, > add in the ip policy statements. > >> > Scott > >> > > >> > On Wed, May 26, 2010 at 12:51 PM, Lazuardi Nasution < > [email protected]> wrote: > >> >> > >> >> Dear you, > >> >> > >> >> I get some problem to do some demo of ServerIron with PBR (route-map) > >> >> feature. It seem that route-map command give no effect so the link > >> >> become fail over, not active-active. My goal is each port can have > its > >> >> own next hop, disregard the routing table or default routes. Any > >> >> suggestion ? > >> >> > >> >> Best regards, > >> >> > >> >> > >> >> Following is the script of my configuration. > >> >> > >> >> > >> >> vlan 2 by port > >> >> untagged ethe 1 > >> >> router-interface ve 2 > >> >> > >> >> vlan 3 by port > >> >> untagged ethe 2 > >> >> router-interface ve 3 > >> >> > >> >> ip route 0.0.0.0 0.0.0.0 192.168.0.254 distance 10 > >> >> ip route 0.0.0.0 0.0.0.0 192.168.255.254 > >> >> > >> >> interface ve 2 > >> >> ip address 192.168.0.1 255.255.255.0 > >> >> ip policy route-map PBR > >> >> > >> >> interface ve 3 > >> >> ip address 192.168.255.1 255.255.255.0 > >> >> > >> >> access-list 2 permit 192.168.0.0 0.0.0.255 > >> >> access-list 2 deny any > >> >> > >> >> route-map PBR permit 10 > >> >> match ip address 2 > >> >> set ip next-hop 192.168.0.254 > >> >> > >> >> > >> >> Following is the "show version" command. > >> >> > >> >> > >> >> Copyright (c) 1996-2009 Brocade Communications Systems, Inc. > >> >> Boot Version 12.1.00T405 Oct 29 2009 10:12:19 PST label: dob12100 > >> >> Monitor Version 12.1.00T405 Oct 29 2009 10:12:19 PST label: dob12100 > >> >> System Version 12.1.00T403 Dec 17 2009 10:21:27 PST label: ASR12100 > >> >> AXP Version: 1.12 Dated: 2009/12/01 10:22:32 > >> >> PAX Version: 0.0 Dated: 2009/07/28 10:35:11 > >> >> MBRIDGE Version: 000b, Device ID # bebe > >> >> > >> >> > ========================================================================== > >> >> Type: Stackable 16GC > >> >> Backplane Serial #: SA19091395 > >> >> Chassis Serial #: Not-Present > >> >> Part #: 46458-00DB > >> >> Version #: 11b626-020202ff-111d8036-00 > >> >> > ========================================================================== > >> >> Active management module: > >> >> 1499 MHz Power PC processor (version 00008021/0030) 599 MHz bus > >> >> 512 KB Boot flash > >> >> 131072 KB Code flash > >> >> 2048 MB DRAM > >> >> The system uptime is 9 minutes 39 seconds > >> >> The system started at 04:21:03, GMT+00, Wed May 26 2010 > >> >> > >> >> The system - boot source: secondary, mode: warm startsoft reset, > total > >> >> resets:11 soft reset, total resets:11 > >> >> > >> >> > >> >> Following is the "show flash" command. > >> >> > >> >> > >> >> Active management module: > >> >> Compressed Pri Code size = 23321502, Version 12.1.00T401 Dec 17 2009 > >> >> 10:08:10 PST label: ASM12100 > >> >> Compressed Sec Code size = 24392549, Version 12.1.00T403 Dec 17 2009 > >> >> 10:21:27 PST label: ASR12100 > >> >> Used Configuration Flash Size=4469, Max Configuration Flash > Size=1441790 > >> >> > >> >> Code flash: > >> >> Size : 134217728 bytes > >> >> Bytes Used : 54544222 bytes > >> >> Bytes Free : 76808192 bytes > >> >> > >> >> USB 0 drive: > >> >> Size : 4102352896 bytes > >> >> Bytes Used : 4096 bytes > >> >> Bytes Free : 4102348800 bytes > >> >> > >> >> No external USB drive found in system > > _______________________________________________ > foundry-nsp mailing list > [email protected] > http://puck.nether.net/mailman/listinfo/foundry-nsp >
_______________________________________________ foundry-nsp mailing list [email protected] http://puck.nether.net/mailman/listinfo/foundry-nsp
