Hi all Just wanted to check if anyone knew whether the configuration that's already applied to interfaces stays valid after a line card is swapped with another.
In this example I am wanting to swap a "BR-MLX-10Gx24-DM 24-port 10GbE Module" with a "NI-MLX-10Gx8-M 8-port 10GbE (M) Module" but I want the relevant configuration for each port to stay exactly the same. I am assuming so, but thought best to check before proceeding. I can assume we'd only run in to issues where moving to a card with less interfaces (e.g. as the startup-config was applied, no matching interface for eth1/9 on an 8-port card would be found). Kind Regards, Josh Farrelly Infrastructure Architect, ICTS. Manukau Institute of Technology
_______________________________________________ foundry-nsp mailing list [email protected] http://puck.nether.net/mailman/listinfo/foundry-nsp
