Hi, Thanks for your reply, but I tried it and nothing happend. If I start with Jumper 8 only the green LED is on, and then if I type boot_linux -F then the 3 LED´s begin to flashing.
And If I start without Jumper 8 the 3 LED´s also falshing. What should I do? I wrote 5 mails to ACME, but I do not get a reply. I´m despaired from ACME and the FOX Board. Maybe anybody can help me. Best regards Patrick Hennig --- In [email protected], "e_cocquerez" <[EMAIL PROTECTED]> wrote: > > --- In [email protected], "paddywalld" <paddywalld@> wrote: > > > > Hi, > > > > Now I tried it with a cross cable, but nothing changed. > > And I don´t believe that the power supply is not correct, because I > > use the Power supply unit from the ACME Shop with the FOX Board LX. > > > > But if I close the Jumper 8 and start the board, only the green LED is > > flashing. As soon as I type "boot_linux -F". All 3 LED´s are beginning > > to flashing. > > > > What should I do? I´m a little bit despaired. > > > > Please help me. > > Best Regards > > Patrick Hennig > > > > Hello, > > I've got also a problem to flash thru lan. I launch boot_linux -F, > close the jumper J8, and restart the fox board. All seems to be ok, > but when I remove the J8 jumper and restart, the board seems to be blank. > I also try with 2 differents power supply, with 2 PC and so on. > > The only way I've found ti flash thru lan is : > close jumper J8 > launch boot_linux -F > little short cut on shutdow connector ( not power off/on) > > Good luck > Eric >
