Thnx, Better mention this in the FoxServe FAQ then, that may save a lot of trial and error.
- Harm --- In [email protected], Roberto Asquini <[EMAIL PROTECTED]> wrote: > > Hi, > > the FoxConsole is already inverting the pins so you need only to connect > the Fox Console DB9 connector with a straight serial cable to your PC > serial port. > Set no hardware flow control and you need only to connect 2-2; 3-3; 5-5. > You can also use a standard complete straight cable with 9 wires > female-male to connect the FoxConsole to your serial PC port. > > Also the default connection parameters for the ttyS0 debug/console > serial port are: 115200, N, 8, 1. > > Best regards, > > Roberto Asquini > > hrmvb ha scritto: > > > > I just plugged it into the FoxServe board, connected a null modem > > cable (see pin-out) between PC and Foxconsole, configured > > Hyperterminal for 19200N81, no flow control, but I don't get anything > > in Hyperterminal. > > > > null modem cable > > pins pins > > ----------- > > 1,6 - 4 > > 2 - 3 > > 3 - 2 > > 4 - 1,6 > > 5 - 5 > > 7 - 8 > > 8 - 7 > > > > Does anybody know how to check which part has problems, cable or > > Foxconsole? > > > > - Harm > > > > > > > > __________ Informazione NOD32 2187 (20070413) __________ > > > > Questo messaggio รจ stato controllato dal Sistema Antivirus NOD32 > > http://www.nod32.it > > > -- > Roberto Asquini > Acme Systems srl > [EMAIL PROTECTED] > http://www.acmesystems.it >
