On Fri, 18 Jun 2021 16:39:52 +0200, Jean SUZINEAU via fpc-pascal
<[email protected]> wrote:
>I've never used open vpn, may be the 10.117 is defined in your
>configuration file ?
>
>For the vpns I've used, the ip adressed were fixed.
The tunnel IP address is defined server side and the route is pushed to the
client on connection. A common VPN address in all tutorials starts with 10.8.0
but this is too common so I have set ours as 10.117.xx
>
>( for route, you can type too something like "route print 10.117.*" )
>
C:\>route print 10.117.*
===========================================================================
Interface List
9...c4 65 16 9d 7e 8e ......Intel(R) Ethernet Connection (7) I219-LM
16...98 fc 84 ed a3 ea ......Realtek USB GbE Family Controller
7...00 ff 2d dd 8d be ......TAP-Windows Adapter V9
21...00 ff 94 a3 1f d4 ......TAP-Windows Adapter V9 #2
14...d0 c6 37 ea 58 3f ......Intel(R) Wireless-AC 9560 160MHz
26...d0 c6 37 ea 58 40 ......Microsoft Wi-Fi Direct Virtual Adapter #3
11...d2 c6 37 ea 58 3f ......Microsoft Wi-Fi Direct Virtual Adapter #4
10...00 50 56 c0 00 01 ......VMware Virtual Ethernet Adapter for VMnet1
13...00 50 56 c0 00 08 ......VMware Virtual Ethernet Adapter for VMnet8
15...d0 c6 37 ea 58 43 ......Bluetooth Device (Personal Area Network)
1...........................Software Loopback Interface 1
===========================================================================
IPv4 Route Table
===========================================================================
Active Routes:
Network Destination Netmask Gateway Interface Metric
10.117.3.0 255.255.255.0 On-link 10.117.3.2 281
10.117.3.2 255.255.255.255 On-link 10.117.3.2 281
10.117.3.255 255.255.255.255 On-link 10.117.3.2 281
===========================================================================
Persistent Routes:
None
IPv6 Route Table
===========================================================================
Active Routes:
None
Persistent Routes:
None
I will need to check this in my connector class, the address to look for has to
be a config item in my application so it can be modified if need be without
rebuilding the app.
Have to figure out how to:
- Retrieve the output of the TProcess execution
- Parse the output for the expected network address.
--
Bo Berglund
Developer in Sweden
_______________________________________________
fpc-pascal maillist - [email protected]
https://lists.freepascal.org/cgi-bin/mailman/listinfo/fpc-pascal