Good point Fred. My craziness is due to the fact that some are working continuously, then another file comes up and BANG, I'm back to 001 again. Not good... Thanks! R.
________________________________ From: Fred Ridder [mailto:[EMAIL PROTECTED] Sent: Thursday, October 04, 2007 10:23 AM To: Combs, Richard; Randall C. Reed; framers@lists.frameusers.com Subject: RE: Bad Autonumbers [EMAIL PROTECTED] wrote: > But the autonumber isn't a page number, it's a paragraph number. You > need to set paragraph numbering to continue. Note, however, that this > affects all paragraph autonumber series; you can't have, for instance, > figure numbers restart while your package numbers continue. Just to amplify a bit: If you set a file's paragraph numbering properties to "Restart", you cannot have a mixture of continuing and resetting counter values. The "Restart" setting affects *all* paragraph numbering series and there is no way for any of them to continue from the preceding file's value. But if you set the properties to "Continue", it *is* possible to reset a specific paragraph numbering series by formatting a paragraph with an autonumber formula that explicitly sets the appropriate counter elements in the series definition to the desired values. Fred Ridder ________________________________ Boo! Scare away worms, viruses and so much more! Try Windows Live OneCare! Try now! <http://onecare.live.com/standard/en-us/purchase/trial.aspx?s_cid=wl_hot mailnews> This material contains confidential and proprietary information of Force Protection, Inc. and its subsidiaries. Copying this material or disclosing such information to others without the Company's prior consent is prohibited. This material may also contain technical data relating to a "Defense Article" within the meaning of the International Traffic in Arms Regulations (22 CFR Part 120). The transfer or disclosure of this information to any non-U.S. person or company without any required export license approved by the United States Department of State, Directorate of Defense Trade Controls may be prohibited under federal law. Force Protection Industries, Inc. _______________________________________________ You are currently subscribed to Framers as [EMAIL PROTECTED] Send list messages to [EMAIL PROTECTED] To unsubscribe send a blank email to [EMAIL PROTECTED] or visit http://lists.frameusers.com/mailman/options/framers/archive%40mail-archive.com Send administrative questions to [EMAIL PROTECTED] Visit http://www.frameusers.com/ for more resources and info.