Warner Losh wrote:
>
> In message <[EMAIL PROTECTED]> "D. Rock" writes:
> : device sio0 at isa? port IO_COM1 flags 0x10 irq 4
> : device sio1 at isa? port IO_COM2 irq 3
>
> These look good. IIRC, the kernel I tested with also had:
>
> device sio2 at isa? port IO_COM3 irq 5 disabled
> or
> device sio2
>
> in it, but I may be misremembering. Just make sure that you use the
> config entry that gives you a port at 0x3e8, since most laptops have
> COM1 and COM2 which really cannot be disabled (well, the BIOS says you
> can disable them, but I've seen a few where the BIOS disabling is
> broken).
Already did that. I used a config entry for 0x3e8 and one for 0x2e8.
Windows 98 configured the card for IRQ 11 I/O 0x3e8 BTW.
Just some more pccard questions:
When will removing cards (and therefor also suspend/resume) work again?
If I remove the netcard or suspend the machine, the system will freeze.
I also get a NMI if I insert my netcard (DLink DE-660). If DDB is compiled
in I can just continue. Interesting the NMI wasn't generated during initial
configuration (via DHCP), but when I tried some ping tests:
pccard: card inserted, slot 0
sio2: irq maps: 0x105 0x105 0x105 0x105
sio2: probe failed test(s): 0 1 4 6 7 9
sio2: irq maps: 0x105 0x105 0x105 0x105
sio2: probe failed test(s): 0 1 4 6 7 9
pccard: card inserted, slot 1
ed0 at port 0x240-0x25f irq 15 slot 1 on pccard0
ed0: address 00:80:c8:8b:66:e9, type NE2000 (16 bit)
bpf: ed0 attached
NMI ... going to debugger
(
[the first two sio2 lines were with config index for port 0x3e8, the other
ones with config index for 0x2e8]
Daniel
To Unsubscribe: send mail to [EMAIL PROTECTED]
with "unsubscribe freebsd-current" in the body of the message
