Hi folks,
Okay, I found that the Adaptec Slim SCSI was apparently
in conflict with the sbc driver. So, here is the latest round
when pccardd attempts to allocate the driver:
aic0: <Adaptec 6260/6360 SCSI controller> at port 0x340-0x35f irq 8 slot 1 on pccard1
aic0: aic6360, dma, disconnection, parity check
pcic0: Error 22 irq 8
aic0: failed to register interrupt handler
device_probe_and_attach: aic0 attach returned 22
I am a bit concerned about the second line, regarding the
"dma, disconnection, parity check". Note that I don't have the
SCSI cable connected to the card, so obviously I don't have the
card connected to anything. (Yes, I know, I could _try_ to
hook it up. :-) ).
Anyway, is this what would be considered "acceptable
behavior, or do I still have a problem?
Kernel parameter is:
device aic0
pccard.conf parameters are of the 2/5 -current cvsup.
Bruce
--
-------------------------------------------------------------------------------
Bruce Burden [EMAIL PROTECTED] Tandem Computers Inc.
512-432-8944 Network Verification 14231 Tandem Blvd.
Auto answer(4 rings) Austin, TX 78726
To Unsubscribe: send mail to [EMAIL PROTECTED]
with "unsubscribe freebsd-current" in the body of the message
