On Monday, September 24, 2012 12:37:30 pm John Nielsen wrote: > I have a machine running "FreeBSD 10.0-CURRENT #0 r240887" amd64 with two ConnectX (InfiniBand) cards. Relevant bits of dmesg and pciconf -lv below. The cards are connected directly to a 10GB Ethernet switch so I need to run them in "eth" mode rather than "ib". Unfortunately they come up in "ib" mode and I don't know how to change it. > > The same hardware works fine under CentOS 6.3, though I need to manually set the cards to 'eth' there as well (which I do using a 'connectx_port_config script from Mellanox that twiddles the mlx4_port1 entries under /sys (sysfs). Under FreeBSD I see these sysctls but I can't set them to 'eth' either via /boot/loader.conf or by sysctl after boot, with or without mlxen and/or mlx4ib loaded: > sys.device.mlx4_core0.mlx4_port1: ib > sys.device.mlx4_core1.mlx4_port1: ib
So this was just fixed (finally) in HEAD in r253048. You can how use the sysctls to change this. -- John Baldwin _______________________________________________ freebsd-current@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-current To unsubscribe, send any mail to "freebsd-current-unsubscr...@freebsd.org"
