On Tuesday, May 17, 2016 06:47:41 PM Gary Jennejohn wrote: > On Mon, 16 May 2016 10:54:19 -0700 > John Baldwin <j...@freebsd.org> wrote: > > > On Monday, May 16, 2016 12:22:42 PM Gary Jennejohn wrote: > > > I tried out EARLY_AP_STARTUP, but the kernel hangs and I can't > > > break into DDB. > > > > > > I did a verbose boot and the last lines I see are related to routing > > > MSI-X to various local APIC vectors. I copied the last few lines and > > > they look like this: > > > > > > msi: routing MSI-X IRQ 256 to local APIC 2 vector 48 > > > msi: routing MSI-X IRQ 257 to local APIC 3 vector 48 > > > msi: routing MSI-X IRQ 258 to local APIC 4 vector 48 > > > msi: routing MSI-X IRQ 256 to local APIC 0 vector 49 > ^^^^^^^ Assigning > > > > > > I tried disabling msi and msix in /boot/loader.conf, but the settings > > > were ignored (probabaly too early). > > > > No, those settings are not too early. However, the routing to different > > CPUs now happens earlier than it used to. What is the line before the > > MSI lines? You can take a picture with your phone/camera if that's > > simplest. > > > > Here a few lines before the MSI routing happens: > > hpet0: <High Precision Event Timer> iomem 0xfed00000-0xfed003ff irq 0,8 on > acpi0 > hpet0: vendor 0x4353, rev 0x1, 14318180 Hz, 3 timers, legacy route > hpet0: t0 : irqs 0x00c0ff (0), MSI, periodic > hpet0: t1 : irqs 0x00c0ff (0), MSI, periodic > hpet0: t2 : irqs 0x00c0ff (0), MSI, periodic > Timecounter "HPET" frequency 14318180 Hz quality 950
The assigning message means it is in the loop using bus_bind_intr() to setup per-CPU timers. Can you please try setting 'hint.hpet.0.per_cpu=0' at the loader prompt to see if disabling the use of per-CPU timers allows you to boot? -- John Baldwin _______________________________________________ freebsd-current@freebsd.org mailing list https://lists.freebsd.org/mailman/listinfo/freebsd-current To unsubscribe, send any mail to "freebsd-current-unsubscr...@freebsd.org"
