On 28.12.18 19:45, Matthias Apitz wrote:
El día viernes, diciembre 28, 2018 a las 09:07:49a. m. -0700, Ian Lepore
escribió:
Try setting vfs.mountroot.timeout= in loader.conf to a value long
enough to let the usb drive get probed reliably. The default is 3
seconds, maybe a value like 5 or 10 would work better for you.
-- Ian
Thanks. I did so, but this does not help. When I does not work even
after 20 secs it fails to mount. After a lot of boot attempts I have the
following picture:
1. It always mounts fine when verbose message is selected.
2. It mounts fine when the line below about 'umass0:1:0: Attached to ... ' is
printed, if it is not, the mount fails later after 20 secs waiting;
Hm, here on my rpi3b+, with an attached usb disk I have to use this
setting in loader.conf:
kern.cam.boot_delay="15000"
With the vfs.mountroot.timeout="xx" I end up in a shell because I'm not
able to mount the partition in time. With the cam.boot_delay things are
working fine.
Maybe this helps?
Andreas
_______________________________________________
freebsd-current@freebsd.org mailing list
https://lists.freebsd.org/mailman/listinfo/freebsd-current
To unsubscribe, send any mail to "freebsd-current-unsubscr...@freebsd.org"
