Dang. I sent the wrong dmesg output. The correct
dmesg follows. Note the broken ACPI.
Copyright (c) 1992-2002 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
The Regents of the University of California. All rights reserved.
FreeBSD 5.0-CURRENT #0: Sat May 11 09:34:09 PDT 2002
[EMAIL PROTECTED]:/usr/obj/usr/src/sys/HOTRATS
Preloaded elf kernel "/boot/kernel/kernel" at 0xc0427000.
Preloaded elf module "/boot/kernel/linux.ko" at 0xc04270a8.
Preloaded elf module "/boot/kernel/miibus.ko" at 0xc0427154.
Preloaded elf module "/boot/kernel/if_rl.ko" at 0xc0427200.
Preloaded elf module "/boot/kernel/snd_pcm.ko" at 0xc04272ac.
Preloaded elf module "/boot/kernel/snd_maestro3.ko" at 0xc0427358.
Preloaded elf module "/boot/kernel/agp.ko" at 0xc042740c.
Preloaded elf module "/boot/kernel/acpi.ko" at 0xc04274b4.
Timecounter "i8254" frequency 1193182 Hz
Timecounter "TSC" frequency 1210791436 Hz
CPU: AMD Athlon(tm) Processor (1210.79-MHz 686-class CPU)
Origin = "AuthenticAMD" Id = 0x642 Stepping = 2
Features=0x183f9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,PA
T,PSE36,MMX,FXSR>
AMD Features=0xc0440000<RSVD,AMIE,DSP,3DNow!>
real memory = 134217728 (131072K bytes)
avail memory = 126021632 (123068K bytes)
Pentium Pro MTRR support enabled
VESA: v2.0, 8128k memory, flags:0x0, mode table:0xc03262c2 (1000022)
VESA: ATI MACH64
Using $PIR table, 9 entries at 0xc00f1720
ACPI-0224: *** Warning: Invalid table signature \M-0\M^Q\M-~\M-G found
ACPI-0181: *** Error: AcpiLoadTables: Could not load RSDT: AE_BAD_SIGNATURE
ACPI-0213: *** Error: AcpiLoadTables: Could not load tables: AE_BAD_SIGNATUR
E
ACPI: table load failed: AE_BAD_SIGNATURE
npx0: <math processor> on motherboard
npx0: INT 16 interface
pcib0: <Host to PCI bridge> at pcibus 0 on motherboard
pci0: <PCI bus> on pcib0
agp0: <VIA 82C8363 (Apollo KT133A) host to PCI bridge> mem 0xe6000000-0xe7ffffff
at device 0.0 on pci0
pcib1: <PCI-PCI bridge> at device 1.0 on pci0
pci1: <PCI bus> on pcib1
pci1: <display, VGA> at device 0.0 (no driver attached)
isab0: <PCI-ISA bridge> at device 4.0 on pci0
isa0: <ISA bus> on isab0
pci0: <mass storage, ATA> at device 4.1 (no driver attached)
pci0: <serial bus, USB> at device 4.2 (no driver attached)
pci0: <serial bus, USB> at device 4.3 (no driver attached)
pci0: <bridge, PCI-unknown> at device 4.4 (no driver attached)
ahc0: <Adaptec 2940 SCSI adapter> port 0x9400-0x94ff mem 0xe3000000-0xe3000fff i
rq 12 at device 10.0 on pci0
aic7870: Single Channel A, SCSI Id=7, 16/253 SCBs
pcm0: <ESS Technology Allegro-1> port 0x9000-0x90ff irq 10 at device 11.0 on pci
0
rl0: <RealTek 8139 10/100BaseTX> port 0x8800-0x88ff mem 0xe2800000-0xe28000ff ir
q 15 at device 13.0 on pci0
rl0: Realtek 8139B detected. Warning, this may be unstable in autoselect mode
lock order reversal
1st 0xc8ea85a4 rl0 (network driver) @ /usr/src/sys/pci/if_rl.c:855
2nd 0xc02a9580 allproc (allproc) @ /usr/src/sys/kern/kern_fork.c:309
rl0: Ethernet address: 00:00:c5:b3:45:24
miibus0: <MII bus> on rl0
rlphy0: <RealTek internal media interface> on miibus0
rlphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
pci0: <mass storage> at device 17.0 (no driver attached)
sc0: <System console> on isa0
sc0: VGA <8 virtual consoles, flags=0x200>
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
atkbdc0: <Keyboard controller (i8042)> at port 0x64,0x60 on isa0
atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0
kbd0 at atkbd0
fdc0: <enhanced floppy controller (i82077, NE72065 or clone)> at port 0x3f7,0x3f
0-0x3f5 irq 6 drq 2 on isa0
fdc0: FIFO enabled, 8 bytes threshold
fd0: <1440-KB 3.5" drive> on fdc0 drive 0
ppc0: <Parallel port> at port 0x378-0x37f irq 7 on isa0
ppc0: SMC-like chipset (ECP/EPP/PS2/NIBBLE) in COMPATIBLE mode
ppc0: FIFO with 16/16/8 bytes threshold
ppbus0: IEEE1284 device found /NIBBLE/ECP/ECP_RLE
Probing for PnP devices on ppbus0:
ppbus0: <Oki Data Corporation OKIDATA OL810e/PS> ENHANCED PCL5,PJL,POSTSCRIPT
lpt0: <Printer> on ppbus0
lpt0: Interrupt-driven port
ppi0: <Parallel I/O> on ppbus0
sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
sio0: type 16550A
sio1 at port 0x2f8-0x2ff irq 3 on isa0
sio1: type 16550A
Timecounters tick every 10.000 msec
Waiting 15 seconds for SCSI devices to settle
Mounting root from ufs:/dev/da0s2a
cd0 at ahc0 bus 0 target 4 lun 0
cd0: <TOSHIBA CD-ROM XM-6401TA 1001> Removable CD-ROM SCSI-2 device
cd0: 10.000MB/s transfers (10.000MHz, offset 15)
cd0: Attempt to query device size failed: NOT READY, Medium not present
da1 at ahc0 bus 0 target 1 lun 0
da1: <SEAGATE ST34371N 0280> Fixed Direct Access SCSI-2 device
da1: 10.000MB/s transfers (10.000MHz, offset 15), Tagged Queueing Enabled
da1: 4148MB (8496960 512 byte sectors: 255H 63S/T 528C)
da0 at ahc0 bus 0 target 0 lun 0
da0: <SEAGATE ST39216N 0010> Fixed Direct Access SCSI-3 device
da0: 10.000MB/s transfers (10.000MHz, offset 15), Tagged Queueing Enabled
da0: 8761MB (17942584 512 byte sectors: 255H 63S/T 1116C)
--
Steve
To Unsubscribe: send mail to [EMAIL PROTECTED]
with "unsubscribe freebsd-current" in the body of the message
