> In message: <[EMAIL PROTECTED]> > "Maksim Yevmenkin" <[EMAIL PROTECTED]> writes: > : I see a lot of "silo overflow" errors under moderate load. > : As a result bytes get dropped on the floor. The Bluetooth > : spec defines extremely simple serial protocol (H4). It simply > : cannot tolerate UARTs that drop bytes. If at least one byte > : gets dropped the entire HCI frame is lost. If HCI frame gets > : dropped then "out of sync" condition exist and all bets are > : off. The only way to get back "in sync" is to send Reset to > : the device. After Reset device goes into standby state and > : all operational state is lost. > > OK. That makes sense. Part of the problem even with even fast > interrupt handlers is that interrupts are masked for way way too much > code in -current, as compared to -stable. What baud rate are you > running at? I'm running at 56k, which isn't the full datarate for > 115200 baud that could be used. Even with a fast interrupt, you'd get > SIO overflows in current, at least according to some reports.
everything is set to 115200, but i think the hardware does something funny with the divisor and internal rate is much higher. with OLDCARD i managed to run Xircom card with fast interrupts and acually got about 50 KBytes/sec. USB devices give me about 60KBytes/sec. > Hmmm, maybe I should get one of these cards, or one a normal sio > cards and run them at 115200 baud. good idea. thanks, max To Unsubscribe: send mail to [EMAIL PROTECTED] with "unsubscribe freebsd-current" in the body of the message