On Tue, Aug 07, 2001 at 09:33:20PM -0700, Brian O'Shea wrote:
> Hello,
>
> I am using a PIII 550MHz UP system running FreeBSD 4.1-RELEASE. It has
> a 3c905B-TX Fast Etherlink XL card.
>
> # ifconfig xl0
> xl0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
> inet 10.34.24.62 netmask 0xfffffc00 broadcast 10.34.27.255
> inet6 fe80::2c0:4fff:fe20:3926%xl0 prefixlen 64 scopeid 0x1
> ether 00:c0:4f:20:39:26
> media: autoselect (100baseTX <full-duplex>) status: active
> supported media: autoselect 100baseTX <full-duplex> 100baseTX
> 10baseT/UTP <full-duplex> 10baseT/UTP 100baseTX <hw-loopback>
Apart from Alfred's suggestions to up some sysctl values, I would
suggest - specifically for 3c905* cards - to explicitly configure
the interface media (add 'media 100baseTX' to your ifconfig line).
You did not report any throughput problems, so this might not be
a problem for you; still, it might be worth trying.
G'luck,
Peter
--
Nostalgia ain't what it used to be.
To Unsubscribe: send mail to [EMAIL PROTECTED]
with "unsubscribe freebsd-hackers" in the body of the message