Hi,
One of our suppliers sent us an MPT adaptor (SAS1064? screen capture
below) to evaluate. Seems like a fairly decent adaptor speed /
feature wise, but I cant seem to figure out a way to monitor the
status of the array ? Is there a way to do so from RELENG_6 ?
---Mike
| LSI Logic MPT Setup Utility v6.04.00.00
(2005.08.29) |
| Adapter List Global
Properties |
| Adapter PCI PCI PCI PCI FW
Revision Status Boot |
| Bus Dev Fnc Slot
Order |
|
SAS1064 03 01 00 02 1.06.00.00-IR Enabled 0 |
[tyan-1u]% dmesg | grep mpt
mpt0: <LSILogic SAS/SATA Adapter> port 0xd800-0xd8ff mem
0xdfefc000-0xdfefffff,0xdfee0000-0xdfeeffff irq 48 at device 1.0 on pci3
mpt0: [GIANT-LOCKED]
mpt0: MPI Version=1.5.10.0
mpt0: mpt_cam_event: 0xb
mpt0: Unhandled Event Notify Frame. Event 0xb (ACK not required).
da0 at mpt0 bus 0 target 8 lun 0
[tyan-1u]% dmesg | grep da0
da0 at mpt0 bus 0 target 8 lun 0
da0: <LSILOGIC Logical Volume 3000> Fixed Direct Access SCSI-2 device
da0: 300.000MB/s transfers, Tagged Queueing Enabled
da0: 75340MB (154296320 512 byte sectors: 255H 63S/T 9604C)
[tyan-1u]%
[EMAIL PROTECTED]:1:0: class=0x010000 card=0x30201000 chip=0x00501000
rev=0x02 hdr=0x00
vendor = 'LSI Logic (Was: Symbios Logic, NCR)'
class = mass storage
subclass = SCSI
cap 01[50] = powerspec 2 supports D0 D1 D2 D3 current D0
cap 05[98] = MSI supports 1 message, 64 bit
cap 07[68] = PCI-X 64-bit supports 133MHz, 2048 burst read, 16
split transactions
cap 11[b0] = MSI-X supports 1 message in map 0x14
--------------------------------------------------------------------
Mike Tancsa, tel +1 519 651 3400
Sentex Communications, [EMAIL PROTECTED]
Providing Internet since 1994 www.sentex.net
Cambridge, Ontario Canada www.sentex.net/mike
_______________________________________________
freebsd-hardware@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-hardware
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
