Hi, I have an idea in my head and would like to know if it is possible.
I want to simulate and test the net80211 mesh code in FreeBSD Current. I have an RSPRO board with 3 atheros cards. My basic idea is to run three jails each having its own network stack, and redirect all data packets coming out/in of the wlan driver to a Server running a home brew application that simulates the medium. That would be great, right? Realtime unchanged code to test, running different application in their own jails. So first I started to test netgraph with a simple test case, I want to receive all packets from one wireless card and see the data in wireshark or tcpdump... This is my netgraph code: mkpeer wlan0: hub lower hook0 name wlan0:lower hub connect hub: wlan0: hook1 upper connect hub: arge0: hook2 lower So if I understood man ng_ether correct, this should capture everything from wlan and redirect to ethernet cable. But I get a panic after a couple of seconds: Trap cause = 4 (address error (load or I-fetch) - kernel mode) [ thread pid 11 tid 100037 ] Stopped at ip_input+0xd8: lw v0,0(s0) I suspect that data flows to all hooks of the hub, and that is a bad thing right? Need to create a special hub node to filter data? Or maybe use two ethernet cables for out resp. in? Is it even possible to do what I want? Or am I thinking wrong? And is there a simpler way? What I want is to test mesh code in a bunch of FreeBSD systems without moving the hardware, one could just stack RSPROs and connected them a big switch and a PC. Hope was I clear in my thoughts. Best regards, -- //Monthadar Al Jaberi _______________________________________________ freebsd-net@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-net To unsubscribe, send any mail to "freebsd-net-unsubscr...@freebsd.org"