On Fri, Feb 22, 2013 at 07:54:07PM -0800, Marc Fournier wrote: > > > > We just picked up 5 new HP DL 360p Gen8 E5-2630 2P servers … just installed > 9.1-RELEASE, and it looks like all of the hardware is detected properly, and > being configured … > > After reboot, I start getting the 'watchdog timeout - resetting' message on > bge0 … I've searched the web, and found the references to setting: > > hw.bge.allow_asf="0" > hw.pci.enable_msi="0" > > but after reboot with those set in /boot/loader.conf (and confirmed via > sysctl -a after login), its still doing it … > > Looking at sysctl -a, even though: > > hw.pci.enable_msi="0" > > is set, I do see: > > dev.bge.0.msi=1 > dev.bge.1.msi=1 > dev.bge.2.msi=1 > dev.bge.3.msi=1 > > still all set to 1 … is that right? > > Don't know if this is useful, but, again, according to sysctl -a: > > dev.bge.0.%desc: Broadcom unknown BCM5719, ASIC rev. 0x5719001 > > === > > If I do an 'ifconfig bge0', it does show the interface as being active, but I > can't ping out on it … > > I even found someone's reference to doing a 'ifconfig bge0 -tso -vlanhwtso' > and tried that … no go … > > Something else I can look at?
You have to use latest stable/9 or stable/8. _______________________________________________ freebsd-net@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-net To unsubscribe, send any mail to "freebsd-net-unsubscr...@freebsd.org"