On 03/08/17 18:03, Freddie Cash wrote:
It's listed in the EXAMPLES section of the ipfw(8) man page.
ipfw nat show config <-- view config for all nat instances
ipfw nat 123 show config <-- view config for nat 123
ipfw nat 111-999 show <-- view logs for nat 111-999
Oops!!!
Been working too much, lately.
Sorry for overlooking this section and posting some noise.
Let's get to my problem now:
_ at boot, my re0 interface is configured with IP 192.168.0.1, along
with an alias (192.168.0.2);
_ my ipfw rules get loaded, issuing a "nat 2 config ip 192.168.0.1"
command;
_ after that ezjail is started, featuring a jail on 192.168.0.3.
From this point on, my aliased packets go out with 192.168.0.3 as
source address. I have to manually run "ipfw nat 2 config ip
192.168.0.1" again, in order to have them correctly going with the
desired IP.
What's the ipfw command that's run at boot time? Sounds like it's
configured to use the interface address instead of a specific IP address.
Yes and no: it uses both, i.e. "ipfw nat 2 config if re0 ip 192.168.0.1".
However, later only the interface is listed from the show command; i.e.:
# ipfw nat 2 show config
ipfw nat 2 config if re0
Guess I'll have to use the "ip", not "if" then.
bye & Thanks
av.
_______________________________________________
freebsd-net@freebsd.org mailing list
https://lists.freebsd.org/mailman/listinfo/freebsd-net
To unsubscribe, send any mail to "freebsd-net-unsubscr...@freebsd.org"
