i found the real problem, it was not the xl driver, but the geom mirror..
if i try to write to an other disk, not in the main systems raid1, then
download is ok, 10M/s...
then i tried to remove one disk from the raid1, and write on it..
the download is OK again...
when i sync the raid array it gives poor performance again 1M/s..
what's wrong?
----- Original Message -----
From: "OxY" <[EMAIL PROTECTED]>
To: <freebsd-performance@freebsd.org>
Sent: Tuesday, December 06, 2005 9:45 PM
Subject: xl driver bug
hi!
i have some trouble with xl driver (3Com 905c-TX) in 6.0-release..
after i upgraded my 5.4 to 6.0 i realized that the incoming traffic
has been dropped to 1M/s..however outgoing is still ok (7-9M/s)..
i tried different protocols, with the same result..
switched off every tcp tuning in sysctl.conf, then rebooted, still the
same..
i saw that the xl interrupt jumps to 2500-5000 (systat -vmstat 1 ) while i
am
downloading with 800-1000K/s (maximum..), but when i upload the interrupt
is
around 800 with 8M/s speed..
please gime me some advice, patch, anything :)
thanks a lot!
OxY
_______________________________________________
freebsd-performance@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-performance
To unsubscribe, send any mail to
"[EMAIL PROTECTED]"
_______________________________________________
freebsd-performance@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-performance
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
