Hi Ivan,
Thanks for the response. Your response quotes my initial uneven
results, but are you also implying that I most likely cannot achieve
results better than the later results which use a larger filesystem
blocksize?
gstripe label -v -s 128k test /dev/mfid0 /dev/mfid2
#newfs -U -b 65536 /dev/stripe/test
#write: 19.240875 secs (558052492 bytes/sec)
#read: 20.000606 secs (536854644 bytes/sec)
(iozone showed reasonably similar results - depending on recordsize
would mostly be writing/reading around 500MB/s, though lows of 300MB/s
were recorded in some read situations).
I suppose my real question is whether there is some inherent limit in
UFS2 or FreeBSD or geom that would prevent going higher than this.
Maybe that's really not possible to answer, but certainly I plan to
explore a few more configurations.
Most of my tuning so far has been trial and error to get to this point,
and all I ended up doing to finally get good results was changing
filesystem blocksize to the max possible (I wanted to go to 128k but it
doesn't let you do that). Apparently UFS2 and/or geom interact
differently with the controller than Linux/XFS. This is no great
surprise.
thanks,
Ben
Ivan Voras wrote:
Benjeman J. Meekhof wrote:
My baseline was this - on linux 2.6.20 we're doing 800MB/s write and
greater read with this configuration: 2 raid6 volumes volumes striped
into a raid0 volume using linux software raid, XFS filesystem. Each
raid6 is a volume on one controller using 30 PD. We've spent time
tuning this, more than I have with FreeBSD so far.
time dd if=/dev/zero of=/test/deletafile bs=1M count=10240
10737418240 bytes transferred in 26.473629 secs (405589209 bytes/sec)
time dd if=/test/deletafile of=/dev/null bs=1M count=10240
10737418240 bytes transferred in 157.700367 secs (68087465 bytes/sec)
I had similar ratio of results when comparing FreeBSD+UFS to most
high-performance Linux file systems (XFS is really great!), so I'd guess
it's about as fast as you can get with this combination.
Any other suggestions to get best throughput? There is also HW RAID
stripe size to adjust larger or smaller. ZFS is also on the list for
testing. Should I perhaps be running -CURRENT or -STABLE to be get best
results with ZFS?
ZFS will be up to 50% faster on tests such as yours, so you should
definitely try it. Unfortunately it's not stable and you probably don't
want to use it in production. AFAIK there are no significant differences
between ZFS in -current and -stable.
--
Benjeman Meekhof - UM ATLAS/AGLT2 Computing
office: 734-764-3450 cell: 734-417-6312
_______________________________________________
freebsd-performance@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-performance
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
